2 adds XRay vision to Minecraft, find ores with ease now. It minecraft xray hacks fullbright, cavefinder, configurable coordinates display, survival fly, fly speed, and much more.
In the user interface, you can choose which blocks get rendered, and which don’t. You can also create additional XRay profiles, and then assign a keybinding to them in-game if you want further customizability. Cavefinder does not automatically turn on fullbright like XRay does. Therefore, you can use it to find torches or other light sources in caves. For instructions on how to configure them, see the configuration page. By default, there is no keybinding set for fly. To enable fly you must set a keybinding for it.
Pressing the fly keybinding enables survival fly. This allows you to use double jump to start flying. It is very similar to being in creative mode. Double tapping the fly keybinding makes you start flying immediately. User interface to make configuration easier. How do I change what blocks are visible? All configuration is done through the user interface.
The default keybinding to open the user interface is J. Inside the user interface you can select or deselect which blocks you want to be visible by simply checking or unchecking the block you want. By default all blocks are rendered except for those on a built in blacklist of obvious blocks you don’t want in XRay. It turns out that getting a complete list of all blocks in the game, especially when third party mods are involved, is a bit difficult. To address this problem, XRay will add the missing blocks to the list as it filters them when XRay is enabled. How do I change what is on the coordinates display?
Open the user interface and at the bottom there is a text area where you can change what is on the coordinates display. Below is a table of the possible options you can use. On mac open finder, hold down ALT and click Go then Library in the top menu bar. Open the folder Application Support and look for Minecraft.